Reading the 1981 ROTARY ENGINE book again
I finally figured out what those ball check valves
and those little springs do in the rotor cooling oil
squirters in the eccentric shaft. They plug the oil
squirters at low RPM!!! At high RPM the ball comes
off the seat and allows cooling oil to flow into
the rotors in theory.
They are to keep the rotors hot when idleing around town
to improve the low-power/low-RPM BSFC and the emissions
I suspect.
The down side is.. if they crude up and plug up you are looking
at an overheated rotor with mucho carbon deposites and stuck
apex seals.
No way do you need that nonsense in a high power
high RPM engine for boat or airplane.
Take those springs and balls out of there and throw them away!!!!
In fact open up the holes so more cooling oil is squirted into
the rotors. A lack of cooling oil can increase the rotor
temperature at 6000 RPM from 190 C to about 220 C.
220 C is 428 F.
If you over do it your oil pressure will fall
off. A high capacity oil pump is obviously called for
here. I think Jim mentions all this in the RB catalog.
I did not fully understand why until now.
BTW Jon what are you doing in regard to this modification?
I know what you should be doing :-)
I'll bet people failing to change the oil or filter on a regular
basis and not keeping it clean has killed more rotary engines
than any other single cause. These ball check valves are
partially to blame.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org