Turrbie@aol.com wrote:
In a message dated 5/9/99 9:34:48 PM Eastern Daylight Time,
rotaryeng@earthlink.net writes:
MAR34807@aol.com wrote:
>
> Ok, since we all decided the pump is not worth it (premix it is), how
about
> using that pad for a prop governor? Need to know the speed of the shaft
> compared to common governors] drives (?), etc to make an adapter plate!
I'm not sure if this answers part of the question you are asking but...
The metering pump drive shaft turns at exactly half the eccentric shaft
speed. I was at one time planning to use this as a drive for a mechanical
fuel pump or backup crank angle sensor.
Bruce Turrentine
Thats the right speed for a prop governor.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org