JMLBlues@aol.com wrote:
The rotor housing temperature distribution is far from uniform in any
direction you care to take. The surface of the steel liner is far hotter (450
F or more at the plugs) than the backside of the aluminum in the water jacket
(200 F or so). The temperature also falls off rapidly in the circumferential
direction as you move away from the plugs. Temperature distribution is
difficult to measure. Measuring the actual thermal distortion in a running
engine (compounded by combustion pressure-induced deflections) is nearly
impossible. Computer models (finite element analysis) can give fairly trendy
indications of what happens, but the models are entirely dependent on
accurate experimental temperature and pressure data (garbage in garbage out).
Designing engines to account for the actual operational conditions is not a
trivial task. Often, what happens inside the engine is counter-intuitive. One
good test is worth a thousand theories. But its sometimes very hard to design
a good test.
Jon Lauter
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org