Jeff Spitzer wrote:
At 12:18 PM 5/9/99 -0700, you wrote:
This is from SAE paper 860560 Material Technology Development
Applied to Rotary Engine at Mazda.
Mazda has done some excellent work. We are so lucky
to have access to these engines at such low cost.
As you can see the temperature difference between the bottom
of the seal and the top of the seal increases at high HP probably
causing the seal to bow and lose pressure.
Yes, but think for a minute about a hot aluminum thing bolted between two
cooler cast iron things. The aluminum thing kinda bows out in the middle
too. The plot thickens....
Jeff Spitzer
It get even thicker when you consider the steel rotor housing liner.
I am getting ready to pop one in the oven... just to see what
happens.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org