Subject: Ball check valve in e shaft for rotor squirters.
From: Paul
Date: 5/10/1999, 7:01 AM
To: zz

Brian D. Cain wrote:


I've done it on mine during engine #4 here.  A local shop here in town
(Rotary Performance in Garland, TX) did the procedure.  I think they
charged me an hour labour for it so it was no big deal.  There's
apparently a kit available from Racing Beat that replaces those with, I
swear, a set of Holley carburetor jets or something.  It's the weirdest
thing.

When I got my eccentric shaft back from the machinist guy at RP, he
blabbed off some stuff about 60000th's of an inch and said, "there's no
reason why those things have to not be squiring oil under 2500rpm".

Speaking of oil pressure - On this particular engine, I still utilize
the factory oil pressure and relief valves/regulators as well as the
Turbo II oil pump and baffle-plate.  At initial startup, I see oil
pressures just barely tipping over 80psi but when the engine is at
operating temperature (+/- 180F degrees) at a ~750rpm idle I see oil
pressure in the low to mid teens. (I apologize; I don't have an oil temp
gauge installed yet)

I attribute this to two things:

One -- Proof that oil does thermally breakdown (smirk)
Two - This oil jet modification allows for more oil volume


As a result of having an extremely low pressure at idle, I've risen the
idle RPM to just over 1100.  My oil pressure, even when temps are at
normal, operating is still around ~20psi.  I, by the way, still use the
factory oil metering (puke) system and also use 20W50 motor oil at all
times.  It's a turbocharged powerplant.

B


Probably not such a good idea for a street car for the above
reasons. Cars can have significant loads at 1000 RPM
unlike prop driven boats and airplanes. I am not sure
about water jet boats.

Paul Lamar

 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org