Subject: Ball check valve in e shaft for rotor squirters.
From: Paul
Date: 5/10/1999, 1:46 PM
To: zz

Turrbie@aol.com wrote:

In a message dated 5/10/99 9:27:56 AM Eastern Daylight Time,
rotaryeng@earthlink.net writes:


 > Bruces video goes through this mod.  He uses a #200 Webber
 > Jet I think.  It is suposed to net a bigger oriface, but not too big.
 >
 > Asside from the preasure loss, what would be the affect on rotor
 > balance with all of that oil in the rotors?  Will it just increase flow
into
 > and out of the rotors, or increase the volume of oil in each rotor.
 >
 > tc


The pressure loss is about 5 psi at idle +/- 3. Anything off idle, the
pressures reflect the same as my other car. The bypass regulator seems to
limit maximum oil pressure to 65 psi. A high volume pump would seem to be a
waist of energy.

I have been told that Mazda is rather liberal about their rotor balance
tolerances. If I recall correctly, the variance between rotors can be up to
15 grams.  With this kind of spread, I don't think the extra amount of oil
will bother the balance.
Bruce Turrentine


The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org