Subject: Ball check valve in e shaft for rotor squirters.
From: Paul
Date: 5/10/1999, 6:49 PM
To: zz

Jeff Spitzer wrote:


First as long as the amount of oil in both rotors is more or less
the same it should not affect the balance.

If it were a bunch different then the balance would be affected.  Remember,
were balancing two couples here.  If the inner couple (the rotors) gets
bigger then the outer couple (the counterweights)also must.  That said, I
wouldn't worry about balance.

As far as the distribution
in the rotor this only affects the rotor balance and that is running
at 2000 to 2500 max RPM. I suspect it only affects the flow rate.

Again, the total rotor weight is being balanced by the cw's at e-shaft speed.

The later post that talks about not running too full is very true.  The
ideal scenario is a "cocktail shaker" oil distibution.  This produces the
highest oil velocities along the wall and gives the best cooling.  If the
rotor is "full" of oil its like trying to shake up a full bottle of salad
dressing.  low velocity = bad mixing = bad cooling.

Jeff Spitzer
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org