Subject: Banjo to AN -10 oil hose fitting.
From: Paul
Date: 5/10/1999, 9:26 AM
To: zz

Perry Mick wrote:

Kruiswyk, Neil wrote:

Ed,

The source was an original banjo fitting as supplied by Mazda.  I
got a used hose and bolt from some salvage place.  I cut the hose off the
fitting and had the SS -10 hose crimped on at a local hydraulic hose maker.

Sorry to disappoint you Ed but there was no rocket science involved
with this one.  :)

Unless you need to make that sharp 90 degree angle the banjo gives you,
you can get the metric to an10 adaptors from Mazdatrix.  These
allow you to use standard an10 aircraft hose and fittings.

There are two sizes, the small ones fit the oil port on the front of
the engine, the large fits the rear (as in the car or a pusher) of
the engine and the '86 and up oil cooler.

I also got some metric banjo fittings once from Maryland Metrics, they
are on the web.  But you have to weld those to tubing.


The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org