Ken Powell wrote:
I would like to say right up front that I am going to run pre-mix.
However, I would like to share this info. While in college in the
early 70's I worked as a mechanic in a Suzuki motorcylce shop. At that
time both street bikes and dirt bikes for all the Japanese
manufacturers were 2-stroke (except Honda, gotta love those guys).
These engines were oil injected, but the critical info is that the oil
metering pump was not a pump at all. It used intake vacuum (and
crankcase vacuum on a Suzuki) to 'suck' the metered oil. The 'pump'
really was only a metering device. BTW, the Suzuki was the most
advanced of the systems because it delivered oil directly to the crank
bearings. I would guess that the rotary works the same way and it
seems that Bruce has investigated this as per his post. Ice should not
be a problem since the orifice is in the block. If you were to mount
the orifice in the intake maifold, it should be located next to the
block. Just my opinion.
Ken Powell
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org