Subject: After market 3 rotor.
From: Paul
Date: 5/11/1999, 1:36 PM
To: zz

Jeff Spitzer wrote:


"no shaft flexing here thankyou"

I'm ignorant to the internals of a 20B.  I always just assumed there were
three mains and that's why the extra center housing was so wide.  Am I to
understand that there are only two mains in a 20B?  

If so I'm not so sure
I'd go around boosting the crap out of 'em.  The e-shaft flexing in a
2-rotor is pretty bad actually but its designed for it.  What some people
might not realize is that the rotary is kinda like a way oversquare piston
engine...really short stroke and huge bore.  Someone out there knows the
actual number but I'm guessing the rotor face has about 30 sq. in. of
projected area.  That means that at 1000 psi chamber pressure the rotor
bearing and shaft must endure 30,000 lb of force.  Ouch!  The idea of
suspending that between two distantly spaced bearings sounds like a recipe
for disaster.  Somebody please tell me I'm wrong.

Jeff Spitzer

You are right on the bore to stroke situation. I was surprised
on the magnitude of the loads on the main bearings. 
Something like 4000 kg 30 degrees AFTDC as I recall. And 
that is with only 180 HP or so. Imagine what it is with 
a blown 730 HP two rotor 13B. The rotor bearing load goes 
out of sight at high RPM due to centrifugal forces. 
The pressure is 270 kg/ cm^2 at 9000 RPM. The 1981 ROTARY ENGINE 
book has this chart mis-labled.

The rotary never ceases to amaze me.

Here is a picture of the stock three main, Three rotor 20B shaft.

The Australian design  somehow cuts the width of the second
intermediate
housing and the length of the e shaft compared to a 20B as I recall. 

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

3rotshaf.jpg