Subject: Main and rotor bearing loads.
From: Paul
Date: 5/11/1999, 10:33 PM
To: zz

Jeff Spitzer wrote:

At 01:54 PM 5/11/99 -0700, you wrote:
Here are the charts in question.
The lower chart should be labeled "Rotor bearing loads".



Paul Lamar

The BMEP shown on the chart (12 kg/cm^2) yeilds 100 hp per rotor.  Note
that the main bearing load is a minimum at about 6000 RPM for this BMEP.

This is an important fact that hasn't been mentioned before.  Because the
pressure loads are so high, the balance of inertia and pressure occurs at a
rather high speed.  This improves the durability at sustained high revs.
At BMEP this balance would occur at lower speeds.  So you guys who are
running about 5K and 150 hp in a 13B are not too far off optimal in this
regard.

Jeff Spitzer

Jeff I think you have it wrong. The ROTOR BEARING loads are
a minimum at 6K. This is where the centrifugal loads are balanced
by the combustion pressure loads on the ROTOR bearings.

The lower chart is mis-labeled. It should be labeled "Rotor bearing
loads". There are NO centrifugal loads on the main bearings because
the e shaft is in complete balance.

Confused the hell out of me too I untill I figured out they had the
lower chart labeled wrong.

mainload.jpg

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

mainload.jpg