Brian D. Cain wrote:
Well guys, I've been hunting up "2 cycle oil" on the net and have been
looking around at the various products available. Boy, there's quite a
few of them!
During my searches, however, some of them have been posting true-to-life
technical specifications about their products. My question is, "what
properties specifically am I looking for in reference to replacing the
factory oil metering system and going 2-stroke?"
Thanks guys.
B
1. Least solid by-products when burnt.
2. Highest "cracking" temperature
possible. The cracking temperature is that temperature when
the oil breaks down into its various parts. If this happens
no solids should be formed.
As Jon pointed out there are other important properties
as well. Lubristy among them I am sure.
Best to order samples and test them yourself or send them
to me. I have access to a labortory quality test oven that goes
up to 1200 degrees F. I have run most tests at 500 degrees F
so far.
The best oils I have tested so far are Quaker State Universal
2-Cycle Engine Oil for air-cooled engines and Exxon Turbo
Oil 2389 and 2380. Both of the Exxon oils are used in airliner
turbo jet engines. Robin tells me 2380 is used in most all engines
& constant speed drives and 2389 is used in only one APU as she recalls.
United is also testing Mobil Jet IV or Mobil Jet II.
Mark Wrathall, can you fill us in on some of this turbine oil
stuff?
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org