Wrathall Mark wrote:
Snip>
Exxon Turbo Oil 2389 and 2380. Both of the Exxon oils are
used in airliner
turbo jet engines. Robin tells me 2380 is used in most all
engines & constant speed drives and 2389 is used in only
one APU as she recalls.
We (Lauda Air) went through an oil of the month phase, swapping
from AEROSHELL 555 , to EXXON 2380, to MOBIL JET II to SHELL 560 and
Back to JET II. (This was mainly a financial decision here, a 3x F1
world champion as CEO gets good deals from oil companies). All of these
oils fulfill the same Mil Spec MIL-PRF-23699F, but with different
proprietary additives. Discussing oils with an overhaul expert at
Lufthansa, I was informed that the different oils have large differences
in their coking tendencies. Our P&W4000 have very low oil consumption,
and suffer from oil coking. Changing away from AEROSHELL 560 helped. The
only other Turbine oil we use is AEROSHELL 390 in the 777 APU. Due to
the cold soak (we fly up to 13 hr legs) and ETOPS APU starting
requirements this APU was initially only certified for use with thinner
than normal oils.
As far as Turbine oil use in rotaries goes, I am skeptical.
Turbines have no plain bearings, and the oil never comes anywhere the
combustion process. The heat that the oil system absorbs is all through
conduction or directly from the hot air bled of the compressor for seal
pressurization. I wouldn't recommend anyone pioneer use of this type of
oil in an aircraft rotary until thoroughly tested on land (or sea).
Maybe Paul Yaw could run it in one of his experiment used parts engines.
As posted last week on this forum by the guy who had discussed it with
the oil company engineer, just heating an oil at atmospheric pressure,
or burning it is not likely to give you results that correlate to it's
use in a rotary combustion chamber. Intuitively 2-stroke oil is designed
for a much more similar job. It would be nice to stop using intuition
and get some facts from someone who has a rotary they are willing to
risk for the furthering of communal knowledge.
So far here in Vienna, I have never seen a rotary more modern
than about 83. The emissions thing isn't as extreme as simple fuel
consumption. We pay over $1 per liter for gas. Austria now has about 60%
of new cars sold are diesels ($0.65/ liter). And most of the petrol
powered ones are VW golfs or smaller. I have the building plans for an
RV-4 and a big concern is noise. If any of you have heard a Diamond
Katana fly past, that is the standard here (Austrian Product). I am
still in the planning phase, but a 3:1 PRSU and effective muffler are
going to high on the priorities list. Homebuilts here are also limited
to 200HP. Steve Beckmans RV-4 is my model.
Thanks Mark.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org