Paul Wrote:
The only reported problems that I have heard about on the IVO prop is
when
it is mounted on a non geared large 4 cyl aircraft engine. In that case
you get these huge torque pulses that reverse twice per rev.
With your set up you get six smaller torque pulses per rev. that do not
reverse. (Turbo 3 rotor 2.17:1 PSRU)
Other objections to the IVO have been due to the flat sections near
the hub. This has caused high drag in tractor airplanes. In a pusher
like yours this part of the prop is in the shadow of the fuselage
and does not seem to matter as much.
I am kind of curious about the variable pitch IVO.
When it is in the relaxed pitch mode (No torque on the internal
steel shaft) is it properly twisted for high speed? 200 MPH or above.
Or is the reverse true? Is it in flat pitch mode?
I am slightly confused about this. Changing pitch and twist at the same
time has me wondering :-)
Paul
Chuck_Harbert@arkwright.com wrote:
The IVO Magnum prop comes in regular pitch(30' to 90") and deep pitch (45" to
105"-RH only). The relaxed position appears to be mid way in the travel which
would make sense since you twist equal directions. I suspect that he makes these
in the middle pitch position. The twist rod in the center of the blade is
connected to a fixed paddle about half way out the blade. As you twist the rod
the flexible prop blade twists for more or less pitch. For high spd the blade is
in full pitch, whereas in takeoff and climb you would be in flat pitch.
Unfortunately, my psru reverses the direction and thus, I can't get the deep
pitch which I would prefer to keep my cruising rpms below 5,500. Currently, with
a 90" pitch and 2,500 prop rpm (5,400 engine rpm w/ Ross 2.17 ratio) the
theoretical spd is 213mph (185kts). I'd like to cruise at 200kts which moves the
rpm to 5,900 rpm (2,700 @ prop) which is too high for continuous service
imho.The deep pitch arangement (17% greater pitch) would solve the problem and
IVO says he's thinking about doing it soon. I may have to bribe him to get him
moving on this.
We've been doing static testing on the engine, but my available time has been
restricted due to the merger and my new job function. Also, had to add
additional radiators (oil & water) to keep temps reasonable. Last weekend we
made several runs up to 5,000 rpm with various prop loadings. Remember I have an
IVO and it's working very well. In my opinion, it's still one of the best props
around, if you properly maintain it.
I've been up to 7 psi of boost @ 4,500 rpm (about 250 hp based on fuel flow),
but had to discontinue due to increasing temps. I'm also waiting for the FAA
(over a month) to send me the registration so I can get an cert insp scheduled
which takes another month. Hopefully, sometime in June, it will take to the sky.
Chuck_Harbert
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org