JMLBlues@aol.com wrote:
Our supercharger on the model 240si takes 22hp to run from the shaft.
Jon Lauter
Rotary Power Marine Corporation
j.lauter@rotarymarine.com
Thanks Jon for the data point. How did you measure or
determine that?
Knowing this we can put some numbers on the situation.
Total engine HP is now of course 262 so the cooling requirements
will be higher but with a boat you have an unlimited
supply of cool water.
With an airplane the cooling system drag would have to be
that much higher given equal aerodynamic cooling efficiency.
If you have the supercharger lower drive pulley diameter
and RPM at that power level we could calculate the bending
stress on the nose of the e-shaft.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org