Herb Sanders wrote:
Paul, the man who built my 13B has a specialty shop and a warehouse full of Ma
zda
engine parts and over 100 RX7s in his salvage yard. He races in competition e
vents
with a couple of RX7 cars and has built several aviation engines. He is on lin
e at
www.RX7heaven.com and his phone is 901-382-8843. I have no connection except h
e
built my engine, but some of the group may be interested in the source of part
s.His
name is Mike Wiggins. BTW, on the oil mix thread, Mike runs gas/oil mix in his
race
cars and has abandoned synthetic in favor of organic two cycle oil because of
plug
fouling with the synthetic.
Regards, Herb Sanders
Ken Powell wrote:
I wonder if the plug fouling was caused by the oil or by the fuel
mixture being too rich somewhere in the operating rev / throttle range.
I can't imagine a petroleum or synthetic oil causing plug fouling
problems in mixtures above 40:1. Is there something different about
the rotary that could cause this? Could the tendency of the mixture
to be richer toward the back of the rotor (relative to direction of
travel) cause the trailing plug to foul? Just trying to understand!
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org