Russell Kent wrote:
Paul wrote:
Roughly speaking a 50% improvement in static
thrust can be obtained with
a radius that is roughly 14% of the duct diameter.
Uh, I must be reading the chart incorrectly. It seems to me that the peak
thrust would be a ring that had a radius of 0.07 (7%) of the inlet *radius*.
If so, then a 40 inch I.D. duct would need a ring with a 1.4 inch radius (2.8
inch diameter). That would make the overall duct diameter 45.6 inches.
Paul, where did I go wrong?
For a 40 inch id diameter duct the radius would be
5.6 inches. This would give an overall duct diameter
of 51.2 inches. The question is what would be the high
speed drag of such a duct?
You are right. A factor of two crept into my calculations.
Good thing somebody reads this stuff :-)
Thanks Russell.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org