Perry Mick wrote:
Paul wrote:
Very interesting Perry. Will you be at or near the MO-GIG flyin?
I would like to take some pictures.
Doubt I'll be flying by then, even if I was, probably wouldn't
have the hours flown off, or be ready for such a long cross-country.
I'll get some pictures on the website in a few weeks, and let the
list know when they are there.
BTW where are the rads? I did not see them in the drawings.
Two rads under the engine, ducted directly to the big naca inlet on the
bottom of the fuselage. Exit air is under the prop near the hub. I
think
the prop duct really helps draws air through the radiators by suction
(radiator duct exit is near the narrowest or lowest pressure area in the
prop duct) or by entrainment caused by the airflow surrounding the
radiator duct exit.
The radiators are mounted horizontal under the oil pan, so the airflow
has to make two 90 degree turns to get through them.
Another small rad, about 1 x 4 x 9 under the pilots seat, plumbed from
the heater port, for cabin heat. I found the long runs up to the
cockpit and back added a lot of coolant to the system and helped
significantly.
Perry Mick http://www.mickaircraft.com/duckt.htm
It occured to me Perry that an some sort of inflatable lip around
the duct entrance would improve the low speed thrust and could be
deflated to reduce the high speed drag.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org