Richard White wrote:
Paul wrote:
Then the duct acts as converging duct speeding up the
airflow through the fan blades at higher forward speeds.
This starts to happen right away as the airplane starts
to move forward. This reduces the maximu PRM of the engine
as the tips of the fan blades goes supersonic sooner.
That is the reason all turbofans having diveraging ducts.
Have we had this conversation before? Most modern bypass fan tip speeds
are supersonic, even at zero forward airpseed.
In an AlliedSignal TFE731 turbofan engine, (as used on a Learjet or
Astra, for example), the fan stage can exceed 11,000 rpm. (If I recall,
100 percent N1 is something like 11,600 rpm). The tip speeds of the fan
are in the neighboorhood of mach 1.4 to 1.5.
Here are some numbers for the GE90 (as used on a Boeing 777, for
example). With a fan diameter of 123 inches and a fan rpm of 2485
producing 105,000 pounds of static thrust at sea level, the fan blade
tip speed is 2485/60 * 123/12 * Pi = 1334 ft/sec which is about mach
1.2, which as the company advertises, is slower than other typical high
bypass engine's fan stages. Would someone double check these numbers?
The reason for a diverging duct in a turbofan engine is not to keep the
tip speeds subsonic. The primary reason is for static pressure
recovery. As the airflow decelerates some of its dynamic pressure is
converted to static pressure, reducing compressor load and dramatically
improving turbojet efficiency.
Happy Times Upon You,
Richard.
Yes as I recall we have.
I am still amazed. Everything I have read so far states that the tips
are below supersonic. I guess it is possible. Perhaps the main reason
the duct diverges is to increase the pressure but any increase in
pressure WILL result in a reduction in velocity. Bernoulli's principle
states as air loses speed it gains static pressure. P1 X V1 = P2 X V2.
To quote Aircraft Engine and Gas Turbine Technology third edition
by Irwin Treager 1995 page 162; "Another primary task a duct must do
during flight operations is convert the kinetic energy of the rapidly
moving inlet airstream into a ram pressure rise inside the duct. To do
this it must be shaped to that ram velocity is slowly and smoothly
decreasing while ram pressure is slowly and smoothly rising."
Further quote page 152; "The velocity of the air at the front of the
compressor must be less than sonic for most present day compressors. In
order to achieve this goal the design of the inlet duct of the airplane
is of primary importance." I see no real difference in the tips of the
compressor blades compared to those of the fan blades.
The simple geometry and RPM has something to do with the tip velocity of
course but the real velocity of the tip relative to the air flow is the
vector sum of the tangential velocity of the tip plus the velocity of
the air in the duct. Perhaps the tips are operating in a boundry layer
or the air on the tips is being dragged around with the blade tips. We
would not know for sure unless we had an air velocity survey of the
inside of the duct near the blade tips.
Be all that as it may the actual tip velocity is really besides my
point. In any event whatever the tip velocity is it will be much higher
at higher speeds with a converging duct as shown in Perry's drawing. If
it can handle mach 1.2 at zero airplane forward velocity then the real
vector tip speed will be much higher when going 200 MPH. Therefore the
RPM of the engine must be reduced to maintain the same vector sum real
tip velocity.
This was and still is my main point.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org