Subject: KISS the PSRU goodbye with a ducted fan?
From: Paul
Date: 5/22/1999, 10:32 PM
To: zz

Perry Mick wrote:

Paul wrote:

There is one other thing that I want to mention about ducted
fans. If the static and low speed thrust is enhanced by a large fixed
lip radius such as shown on Perry's web site;

http://www.mickaircraft.com/duckt.htm

Then the duct acts as converging duct speeding up the
airflow through the fan blades at higher forward speeds.

This starts to happen right away as the airplane starts
to move forward. This reduces the maximu PRM of the engine
as the tips of the fan blades goes supersonic sooner.

That is the reason all turbofans having diveraging ducts.

This is all true, but if you read Piolenc's book, you will
see that low speed, by low speed I mean 200 mph, ducts are
designed this way.  I think it's the key that will make it
work.

When cruising at 200mph, airspeed thru the fan is 267mph,
the prop/engine is turning 6100 rpm.  The tips are not supersonic
at this rpm and prop diameter.  It would take 7000 or more to
get that.  I don't think I have the hp to get to 7000 rpm
with this setup.

The vector sum of 267 MPH and the tip speed at 6100 RPM
is 726 MPH. or mach .97.  At 42 degrees F mach one is 750
MPH at S.L.. I based this on a fan diameter of 37 inches as I recall. 
I got 985 FPS or 671.6 MPH for tip speed. I checked back and the
diameter is really 37.5 which of course will increase this somewhat.

Most prop designers like to keep the tip speed below
mach .8 which is 600 MPH. According to  Richard White
much higher mach numbers are acceptable for turbofan 
blades in a duct.

The fans in turbofansare made from titanium and are much
thinner and stronger than your average prop blade tip.
They are also swept back.

It might work I am not sure. I hope it works.
I can hardly wait to see some performance data :-)


Turbofans have diverging ducts because they cruise at 500
mph, and have to slow the air down to avoid supersonic tip
speeds.  When we're going 200mph, we can speed the air up
to get better efficiency.

You could run the engine faster and get more HP out of it
with an open prop of the same diameter.

One of the advantage of the inflatable lip is this is
no longer a problem. You can use a diverging or difuser type
duct for high-speed/high-RPM efficiency and still enhance
the static and low speed thrust.

Paul Lamar



The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org