Perry Mick wrote:
Paul wrote:
Richard White wrote:
Paul wrote:
Then the duct acts as converging duct speeding up the
airflow through the fan blades at higher forward speeds.
This starts to happen right away as the airplane starts
to move forward. This reduces the maximu PRM of the engine
as the tips of the fan blades goes supersonic sooner.
That is the reason all turbofans having diveraging ducts.
Have we had this conversation before? Most modern bypass fan tip speeds
are supersonic, even at zero forward airpseed.
In an AlliedSignal TFE731 turbofan engine, (as used on a Learjet or
Astra, for example), the fan stage can exceed 11,000 rpm. (If I recall,
100 percent N1 is something like 11,600 rpm). The tip speeds of the fan
are in the neighboorhood of mach 1.4 to 1.5.
Here are some numbers for the GE90 (as used on a Boeing 777, for
example). With a fan diameter of 123 inches and a fan rpm of 2485
producing 105,000 pounds of static thrust at sea level, the fan blade
tip speed is 2485/60 * 123/12 * Pi = 1334 ft/sec which is about mach
1.2, which as the company advertises, is slower than other typical high
bypass engine's fan stages. Would someone double check these numbers?
The reason for a diverging duct in a turbofan engine is not to keep the
tip speeds subsonic. The primary reason is for static pressure
recovery. As the airflow decelerates some of its dynamic pressure is
converted to static pressure, reducing compressor load and dramatically
improving turbojet efficiency.
Happy Times Upon You,
Richard.
Yes as I recall we have.
I am still amazed. Everything I have read so far states that the tips
are below supersonic. I guess it is possible. Perhaps the main reason
the duct diverges is to increase the pressure but any increase in
pressure WILL result in a reduction in velocity. Bernoulli's principle
states as air loses speed it gains static pressure. P1 X V1 = P2 X V2.
I too thought the tip speed in a turbofan had to remain subsonic, but
may be wrong. This is what Piolenc says also.
If you look at these new, big turbofan's produced for the 777, I think
they are 10 feet in diameter. The fan has fewer blades, but wider chord
blades than the older engines, and I believe they are only turning
around 1500 rpm. I was looking on the internet a few weeks ago for more
technical info on these engines, but it is not readily available.
My duct/prop may not be optimum yet. What I did was follow Piolenc's
recommendation to maximize mass flow, and minimize delta-v. You can
only take this so far. In my case, I maximized mass flow until I had an 8
degree exit tail cone, to avoid airflow separation. My exit velocity at 200mph
is 215mph, for a delta-v of 15mph.
If I need more power, I'm ready to install a turbocharger, just need to
figure out how to squeeze it in such a tight package.
Perry
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org