Jeff Spitzer wrote:
Paul Lamar Wrote:
Most prop designers like to keep the tip speed below
mach .8 which is 600 MPH. According to Richard White
much higher mach numbers are acceptable for turbofan
blades in a duct.
The fans in turbofansare made from titanium and are much
thinner and stronger than your average prop blade tip.
They are also swept back.
It might work I am not sure. I hope it works.
I can hardly wait to see some performance data :-)
Paul
There is a very important reason for this. It's called drag divergence
mach no. When the local velocities on your airfoil go supersonic the drag
will increase rapidly. This will consume massive amounts of torque for no
add'l thrust. You WILL find that you can't get to 7000 RPM if you are
approaching mach 1 with your tips not because of pitch but because of drag
divergent tips. The turbofan guys have spent billions developing computer
codes to design proper blade/duct systems that allow them to run high tip
speeds. Previous experience without these codes was the reason for Paul's
post about usually keeping the tips subsonic. Unless you have used one of
these advanced designs you will certainly have efficiency problems at tip
speeds over .8M. What airfoil are you using...hope it's supercritical.
Jeff Spitzer
This partially answers my last question.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org