Subject: KISS the PSRU goodbye with a ducted fan?
From: Paul
Date: 5/25/1999, 7:16 AM
To: zz

F. Marc de Piolenc wrote:

Forgive me for butting into this debate, but as co-author of a book on
ducted fan design I think anybody interested in the subject would
benefit by visiting my Web page:

http://www89.pair.com/techinfo/MassFlow/massflow.htm

Some of the comments I've seen miss the key differences between a ducted
fan and a turbofan installation.

Marc de Piolenc
Mass Flow

Your web site is linked on the ACRE NL web site below Marc
as of last week.

I read it over but I still have some questions. I tried to buy
the book but I did not want to leave my credit card number
on the internet. I believe you were out of town last week.
Send me your phone number by private email
and I will buy a copy of your book.

Are you familiar with Perry Mick's design?
See the drawing below.   Perry-Mick-wb.jpg

I noticed the duct converged which implies an increase
in the forward air velocity in the duct. His fan diameter
is 37.5 inches and his fan RPM is 6000 RPM. By my calculations
that will result in a tip velocity of about mach 0.97 at
200 MPH, S.L and 42 degrees F. Is that about right or am I doing 
something wrong?

Is there some magic shape of duct and fan tip that we can
use to allow us to run the fan tips supersonic? Perry is
using a Clark Y airfoil with a three blade fan and a 
four inch cord with a forty degree pitch as I recall.

Could you use this information presented above to make a 
plot of net thrust minus the drag of the duct as a function
of forward velocity given 180 engine HP at 6000 RPM?
  
Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Perry-Mick-wb.jpg