Wrathall Mark wrote:
Snip
>The fans in turbofans are made from titanium and are much
>thinner and stronger than your average prop blade tip.
>They are also swept back.
The Blades on the GE90 are Carbon Fiber, the leading and trailing edges
plus the tips are shrouded in titanium for erosion protection. The
titanium carries no load. The shrouding on the trailing edges helps
prevent delamination from a birdstrike. The Blades on the Roll-Royce
Trent are slightly forward swept. (There are absolutely no absolutes).
Snip:
> > > Here are some numbers for the GE90 (as used on a
Boeing 777, for
> > > example). With a fan diameter of 123 inches and a
fan rpm of 2485
> > > producing 105,000 pounds of static thrust at sea
level, the fan blade
> > > tip speed is 2485/60 * 123/12 * Pi = 1334 ft/sec
which is about mach
> > > 1.2, which as the company advertises, is slower
than other typical high
> > > bypass engine's fan stages. Would someone double
check these numbers?
The GE90 at cruise averages about 92% N1 on our 777. This corresponds to
2080RPM (100% is 2261 - Red line is 109%) so the numbers pan out as:
2080/60*123/12*pi= 1116 Ft/sec at cruise.
Assuming an average OAT at 36 000 ft is -56°c, this gives a tip Mach
number of about 1.36 with no forward speed. The aircraft normally cruise
at Mach 0.84 but not knowing the exact profile of the intake cowl, I
have no idea what the airstream mach number is when it gets to the fan.
The acoustic panels in the cowl are working pretty hard.
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org