Subject: Holley two-barrel PRO-JECTION stand alone fuel injection
From: Paul
Date: 5/27/1999, 9:42 PM
To: zz

Mike Wills wrote:

Yvon,
 Didnt mean to rain on your parade there. What has been your experience
with the unit? Have you flown it or is it a recent mod to your airplane?

 Maybe I should add a little more detail to my previous negative comments.
My Z car was originally carbuereted (Holley 3310 4 barrel) but I fell
victim to that common hot rodders disease - newer technology is better than
old. So I upgraded to the ProJection 4. After much tweaking and fiddling I
did finally get it to the point where it made good power and was drivable.

However I never could get it to idle properly. The engine had a cam with a
moderate amount of overlap and fairly "lumpy" idle with the associated low
idle vacuum. The ProJection controller couldnt deal with the low manifold
vacuum at idle. The engine would go into an oscillation of idle speed,
oscillations increasing until finally the engine would die as the idle
swung low. If I set the idle speed up around 1400RPM there was enough
vacuum that things would settle down but 1400RPM is a bit much for a street
car.

 The thing that disturbed me the most was Holley's response. After all this
wasnt a particularly radical engine. I would consider it a mainstream hot
rod engine which is Holley's target market. They ultimately told me that
the only choice I had was to re-cam the engine with something that had more
idle vacuum. This isnt the response you expect when you upgrade from a
companies low end product (the 3310 carb) to their high end product. This
obviously was a product in need of serious further development when I
bought it. When I installed it Holley didnt offer the O2 sensor feedback
option. That came out later, presumably after enough of us complained
and/or returned our ProJection systems. Maybe it works better now with the
O2 sensor but I will never have first hand knowledge of that cause I
wouldnt buy another one.

Mike Wills


 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org