Chuck_Harbert@arkwright.com wrote:
Paul, I was concerned about Ross gearbox temps if I reduced the oil flow down to
.030" in order to make it drain thru the 3/8" pipe opening. It just didn't seem
to be enough cooling oil. I tried going with a .040" and the gearbox fills up
with oil rapidly which causes the seals to leak. After a couple of tries, I
decided to scavenge the oil with a pump. I now run a .055 (3 times the flow) and
the oil level stays correct (which is about 1" in the bottom of the case), and
my seals don't leak. If my elec scavenge pump quits, it will still drain back,
but the gearbox will be full and seals will leak.
I've also installed a temp sensor on the drain line. Even under high prop load,
I'm getting 10+ degF cooler oil exiting due to the splash of the oil against the
lower temp case (I assume). This also will give me early warning if I've got a
problem with the gears.
Does Jeff, or anybody else, see a problem with this approach.
I suspect the moving gears act like a pump. The oil outlet
is probably in the wrong place. This is especially true if
the ratio used results in the ring gear rotating at prop
speed. I discussed this with the guy from New Horizons at Bensen Days
and he
said he discovered the same thing. I forgot to write down his name
but give him a call and ask where he placed the scavenge oil out let.
There is probably a little oil scrapper/scoop in there.
(940) 433 2007. In Texas.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org