Jeff Spitzer wrote:
Chuck_Harbert@arkwright.com wrote:
Paul, I was concerned about Ross gearbox temps if I reduced the oil flow
down to
.030" in order to make it drain thru the 3/8" pipe opening. It just
didn't seem
to be enough cooling oil. I tried going with a .040" and the gearbox
fills up
with oil rapidly which causes the seals to leak. After a couple of tries, I
decided to scavenge the oil with a pump. I now run a .055 (3 times the
flow) and
the oil level stays correct (which is about 1" in the bottom of the
case), and
my seals don't leak. If my elec scavenge pump quits, it will still drain
back,
but the gearbox will be full and seals will leak.
I've also installed a temp sensor on the drain line. Even under high
prop load,
I'm getting 10+ degF cooler oil exiting due to the splash of the oil
against the
lower temp case (I assume). This also will give me early warning if I've
got a
problem with the gears.
Does Jeff, or anybody else, see a problem with this approach.
No particular problem but I would hate to have to add a scavenge pump to a
gearbox that should just drain back to the tank. Why not install a bigger
drain line? I'm not familiar with the Ross unit. The only *possible*
problem would be cavitation of the scavenge pump at altitude. If you
measure the pressure at the pump inlet you can get a feel for how much
margin you have. Hot oil will boil at an absolute pressure of about 12-15
in. hg. That's a guess from memory. If anybody really cares I'd look up
the actual number.
Jeff Spitzer
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org