Yvon Cournoyer wrote:
Good evening Mike,
Thanks for your further comments,
I was very surprised at the reaction of the net. Especially since it does not
correspond to my experience with my Holley FIS.
I initially flew in Oct 1990 with a GM Rochester 1978 Two-barrel downdraft
carburator. The Rochester had 1 inch 11/16
throats. I changed to the Holley FIS in June 1995. The Holley has 2 inch throats.
I have flown with the Holley, since then, quite safely I feel. The 13B is very
smooth from 700 to 5500 rpm, I did not have much trouble adjusting the idle and
midrange, even though I am still using my own homemade intake manifold. However,
using essentially the same intake manifold and the same propeller, the Holley
will not rev much above 5500 rpm while my old Rochester would reach 6000 rpm.
However, I have survived my initial shock at the reaction of the net and in fact,
am encouraged by all I am learning on the net.
Yvon.
What is the pitch and diameter of your prop Yvon?
Do you have an EGT gauge on there? If so what temperature
does it run?
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org