Yvon Cournoyer wrote:
Good morning,
My propeller is home made by a local artisan. 74 X 50 X 6 inch max width.
I have had a Westach twin EGT since the beginning but they were never fully useful in
flight since they would remain pegged at max of 1600 degrees at W.O.T., ( for exemple,
in climb at W.O.T. at 5300 rpm) also I needed to renew the senders maybe every 50 hrs
or so because they stopped sending.
Recently, I fabricated a new configuration SS exhaust with muffler and installed an
oxygen sensor feeding a stand alone A/F ratio monitor. This new configuration allows
only one EGT sender but more useful. I am learning (grudgingly) that my 13B needs a A/F
ratio of about 12.7 to run smoothly.
Also beginning to admit I have been running my 13B engines on the lean side of peak EGT
since the very beginning. (Rex Taylor warned me about that in January 1988, but I
misinterpreted his message.)
Yvon
Paul a écrit:
I assume you burn only unleaded auto fuel as leaded 100LL aviation fuel
will
eventually degrade that O2 sensor. I did not know that about Westach
EGT.
You need something else. Running engines on the lean side of peak mostly
refers to piston engines with burn-able exhaust valves :-) In a rotary
that is one of it's main advantages.
Do you have a manifold pressure gauge? If so what does it read 5300 RPM
WOT?
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org