Bill Freeman wrote:
Paul,
The KIS is a sandiwch composite as I remember. As far as the
primary bending loads in the aft fuselage, the top and bottom
will be carrying the primary loads, with the affected (air exit )
locations primarily in shear. I would recommend a glass
reinforcing layup much like your 0.065" doubler, done about
3 inches wide and about 4 plies inside and 4 plides outside
joined together at the edge of the opening, with about a 1'
glass to glass flange around the whole opening. This is just
eyeball, but should be fine.
Otherwise, these guys are composite folks, so dump the 5"
round duct and design a proper diffuser in solid foam and
glass over then remove the foam, as per SOP. Much better
pressure recovery, also high pressure drop in aeroduct, rough
inside.
Also, seems like a HUGE rad area. Did I miss something?
16 x 28 x 2 * two !! Seems like 600-800 cu. inch was OK, so
why two rads? Or perhaps they should be only 1" thick?
Also want smooth ducting to reaccelerate the air after the
rads, not clear in dwg, may want to explain this clearly.
I thought I said one inch. Anyway I meant one inch :-).
Good design, seems to me.
Bill,
Good suggestions Bill.
I thought some more about removing the bulkhead behind the front
seats and replacing it with a longitudinal beam incorporating
the console to take the bending loads and I think it is the way to go.
The bulkhead in question is the double U shaped thing just behind
the front seats. It interferes with traditional adjustable seats
such as Geo Tracker seats.
As you can see in this picture the center console stops short
of the firewall. I also think the rudder pedals will have to be
moved closer together to make room. Another advantage is it will beef
the firewall where the high loads go in from the front gear without
adding
much weight. There will be some additional plys on the inside of
the fuselage to distribute the compression load from the spars
into the fuse structure but these could be only several layers
of carbon fiber.
What do you think Bill?
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org