Anderson Ed wrote:
Hi Chuck,
I just removed my 13B for a tear down and found that my PSRU also had a
small oil leak around the seal. Due to the location of the oil return
fitting on my oil pan being higher than the PSRU, I suspect that my
housing must nearly fill with oil before it gets high enough to drain
back into the pan thereby contributing to oil pressure on the seal and
the leak. While I have the oil pan off, I intend to have another
fitting welded to it lower down so the oil will not have to travel up
hill.
Ed
You should drop the bottom of that pan while you are at it Ed.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org