Subject: S51 Chevy big block V8 crashes.
From: Paul
Date: 6/1/1999, 8:36 AM
To: zz

Charles P. Kuss wrote:

Paul,
 I know Tom Hahn, Stewart 51 test pilot, personally. He stated that he
has had THREE forced landing in the factory prototype. All three were
due to the failure of the oil supply line from the engine to the PSRU
failing. This not only caused instant zero oil pressure, but covered the
front and left side of the canopy with large amounts of oil. He feels
that his survival was due to the fact that he was fortunate to have an
airfield nearby all three times.
 The last time this happened, was on takeoff. He had to split S at 800
feet to return to the runway. He had so much energy, that he continued
off the far end of the runway. Of course, there was a culvert at that
end of the strip. The landing gear was removed and wing damage was done
by false drop tanks and bombs (installed by the factory people over
Tom's protests) which were sheered off after the loss of the landing
gear. The hard points were driven up through the wings in several
places.
 Several of the more knowledgeable on the list have warned us about the
devil being in the details. It's not the engine that fails, but the
SYSTEMS!! Please don't cut corners on your fuel, oil and cooling systems
folks!!
Charlie Kuss



Unfortunately nobody has more than three hundread hours or so on this
engine. After the first "oil line failure"  I asked Jim Stewart if he
had
magnafluxed the crank and rods and he said "NO!" He merely replaced the
block ???? 

I find it a little strange that an oil supply line failed three times in
a row. Not likely if using AN fittings and well supported  stainless
steel 
double braided oil line in my race car experience.

The whole S51 program hinges around the use of that engine.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org