Subject: Parts needed to convert to 2-cycle oil metering
From: Paul
Date: 6/2/1999, 10:27 AM
To: zz

Bob Darrah wrote:


Brian, I can tell you how I did it-yes, you have to remove the front cover.

While you are in there, remove the injector drive shaft and gear.

In the front case, locate the oil passage that feeds the injector pump.  Tap the
passage in the mateing flange with a 1/4-20 tap, only 1/4 inch deep.  Blow out
all chips!  Put in a 1/4-20 allen head set screw (with sealent).  That way, if you
want to go back to stock, you can easly remove the plug.

Good luck!

Bob Darrah
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org