Brian D. Cain wrote:
Ok. I just want to make sure I'm clear and not off my rocket on this.
The premix ratio, as an automotive guy here *removing* the oil injection system
completely, per what I've read, should be 1oz 2-stroke PER 1gal fuel,
or approximately 128:1.
This rotary isn't your garden-variety stock engine. It's already in the 275 to 300
crank horsepower range and is about to get upped even higher than that with the
changeover of a Garrett-made TO4B turbocharger and modification to the fuel system.
Seeing how this thing already runs hotter, would one of you guys agree that I should
aim for a bit "richer" mixture, say 2oz PER 1gal, or 64:1?
The cost of the 2-stroke oil is no big deal. I figure about $10/gallon of the stuff.
Absolutly Brian given the HP of this engine even 3 oz per gallon may not
be out of line. Since we cannot measure the apex seal temp it is better
to over do it rather than under do it. Watch for smoke and check the
condition
of the rotors and apex seals from time to time through the exhaust
ports.
I'm currently aiming for these qualities in a 2-stroke oil:
- 2-cycle made for water-cooled engines
- TC-WIII certified
- Ashless
- Made as an injector oil and/or oil/fuel premix
Thanks. Boy I can't wait! I wish I would've done this 6000 miles ago when
I was rebuilding this thing.
B
I would go with 2 stroke oil for air cooled engines as the apex seals
run hotter than piston rings.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org