Subject: COZY: Fule lines in passenger compartment
From: Paul
Date: 6/3/1999, 7:05 PM
To: zz

Bulent Aliev forwarded:

Subject: Re: COZY: Fule lines in passenger compartment
Date: Wed, 02 Jun 1999 13:25:51
From: "Robert L. Nuckolls, III" <nuckolls@aeroelectric.com>
To: "Cozy List" <cozy_builders@canard.com>



There is one thing that bothers me quite a bit on the Cozy design and that
is
having fuel and vent lines running thru the fuselage. This is not good and
indeed would not pass muster on a FAR 25 aircraft. Many aircraft have
fuel and vent lines that run thru the passenger cabin however they are
shrouded (double walled). and the cavity drained overboard.

  Curious. I've done a quick word and phrase search in Part 25 and
  did find references to shrouding fuel lines in vicinity of fuel fired
  heaters to prevent leaking fuel from entering the ventilation system.
  I found no requirement for extra ordinary enclosure of fuel lines in
  the cabin or anywhere else. There were lots of words about adequate
  support, showing that materials used were suited to task, and taking
  special note of fuel lines that run through especially hot or cold
  areas.

  I've been a stong advocate of electric primer systems to avoid
  running primer lines all the way to the pilot's position. Electric
  primers plumbed to 4 or 6 port primer systems offer a unique
  opportunity to build a stand-by fuel delivery system that is
  totally independent of the normal running system.

  The larger plumbing used to carry fuel from tanks to selector
  valves and ultimately to the engine don't figure high on the list
  of hazards in accident history . . . indeed, one builder's quest
  to keep fuel out of the cockpit gave rise to a fuel selector handle
  that Mr. Denver couldn't reach . . . not a bad deal for the guy
  who designed it but a real problem for the guy who bought the
  airplane.

  For canard-pusher aircraft, the potential for long runs of fuel
  lines in cockpit are certainly greater . . . but keep in
  mind that fuel line failures happen most often at compormised
  joints or at locations where lines are not properly supported
  and protected from chaffing.  If the joints you make in
  your fuel lines are no greater in number than those found
  in the average Cessna or Piper, I'll suggest that aside from
  the obvious need for mechanical security of the installation,
  there's not much of an argument for the use of exotic tubing
  for fuselage fuel handling . . .


       Bob . . .

                       ////
                      (o o)
       ===========o00o=(_)=o00o=========
       <  Independence Kansas: the     >
       <  Jurassic Park of aviation.   >
       <  Your source for brand new    >
       <  40 year old airplanes.       >
       =================================
          http://www.aeroelectric.com


The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org