Subject: Collapsing your wing tanks with high pressure EFI pumps???
From: Paul
Date: 6/3/1999, 7:39 AM
To: zz

Anderson Ed wrote:

Bob, I don't know if Tracy had that experience, but while I had my 13B
on a test stand I was feeding it from a fairly substantial six gallon
pastic marine fuel container.  I had it sitting on the ground about 2
feet below my header tank.  While running the engine this time I notice
it was starting to run rough, I then notice that the plastic fuel tank
had practically collapsed from the pressure differential caused by the
EFI pumps sucking fuel from it.  I had failed to open the tank's vent
valve.  That is when I became convinced that the design would have no
problem pulling fuel from the wing tanks.  

Now, I realize that the pumps
may well develop that pressure differential in the fuel line even
without a header tank, however, my header tank is designed to keep the
fuel line fittings to the pumps submerged in fuel at all times.  The
pump feed  fittings on the bottom of the header tank are below the fuel
level of the wings and the pumps are low enough on the firewall relative
to the header tank to have their lines filled with fuel at all times
(unless you run the header tank dry which I inadvertently did one time
fortunately at 8000 ft).  

One thing you may want to consider and that is
if you use a small volume header tank and run it dry it does not take as
long to get it filled again and the engine running again than if you use
a large header tank and run it dry.  Just a thought.

Ed Anderson


The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org