Subject: Collapsing your wing tanks with high pressure EFI pumps???
From: Paul
Date: 6/3/1999, 9:07 AM
To: zz

Kruiswyk, Neil wrote:

Ed Anderson wrote,

One thing you may want to consider and that is
if you use a small volume header tank and run it dry it does not take as
long to get it filled again and the engine running again than if you use
a large header tank and run it dry.  Just a thought.


Can't agree with you here Ed.  Why does the header tank have to be full to
run the engine?  So long as there is enough fuel to develop pressure...
(fill the lines) the engine will run.  It will take just as long for me to
put a quart of fuel in my 11 gal tank as it will for you to put 1 quart in
your 1.5qt tank.  Actually, I can do it twice as fast since I have 2
transfer pumps, one from each wing tank that I can run together (or
individually).

  And Paul...  why would you want a wobble fuel pump?  (assuming you
had twin electric fuel pumps)  If both pumps fail..  it is just not your
day.  If the electric's fail...  the EMU  and ignition are gone as well.
(also not your day)

Only if you cannot run off the battery. The most likely scenario is 
the alternator fails. Perhaps just the alternator belt. 

I  had it happen in my Cessna. The A&P IA doing my annual failed
to tighten the bolt holding tension on the belt. I flew to 
Lost Wages at night and had to turn off everything to save
the battery for the radios and nav lights  going into McCarran.

If you can off load the battery drain you can fly further on what's 
left in the battery. A separate back up battery fully charged at all 
times is also indicated.

This wobble pump is not as important if the pump drain is only
6 amps as Ed says. I forgot what Tracy says is the current drain of
his EFI/ign system.


  On a side note...  last fall I had the cowls off, working on my fuel
injection system and I ran up my engine.  It idled fine..  ran fine to 2500
or so but then started going lean beyond that...  I was able to correct with
the mixture control up about 3500...  A little head scratching and a few
more run ups later I discovered that I had taken the power connections off
both fuel pumps!!!  My system operates at 60PSI but there was just enough
"head" pressure in the header tank to keep things running.  Mind you..  this
would probably just take me to the scene of the accident.  :)

Neil

 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org