Gerry Hess wrote:
Hi Bruce,
Here's my notes on the e-shaft when I was building it in Chris's shop.
To convert to a single rotor.
Cut up the old flywheel into a pie shaped wedge with a flat bottom at 90 deg
from the woodruff key. Drill two 3/4" holes in it and assemble to the
crankshaft. This is used as the faceplate drive and milling stand to support
the crank end when cutting the keyway on the front end, and drilling new oil
jet holes and oil feed hole in front journal.
Machine off the front rotor. Leave 50 thou for grinding the journal and
shaft, but cut the oil feed groove .250" wide in the new front journal to
depth of .025" below finished crank diameter. Note that shaft and journal
length are critical as the end play in the engine is determined by this.
Stick with original lenght and dimension.
Grind shaft and journal to finished dimensions and cut to length. Drill and
tap the crank end for the same bolt you took out of the stock one, 16 x 1.5
metric. Get rid of the oil bleed / relief bolt.
Plug old oil spray hole with a #10-32 setscrew.
Drill a (.079)2 mm oil spray hole at the low side of the crank on the
flywheel side and angle it into the rotor by 20 deg. Start the hole .250
away from the machined edge of the rotor journal. Check during assembly that
the rear bearing holder does not cover or impede this hole. The rear bearing
is used as the location of the oil jet as the oil then discharges though the
back plate and does not suck hp by hitting the front counterweight.
Cut the rear casing stationary gear back in the lathe about .250" - flush
with the bearing as it protrudes past the bearing shell, and machine off
all of the remaining gear teeth.
Drill a .20" hole thru the crank on the front journal oil feed groove.
Drill and tap a hole in front end of crank for bolt, chamfer edge to 60
deg., and thread to 16 x 1.5 metric.
Chamfer all new and old oil hole edges.
Cut the new front keyway at 180 deg. From the Woodruff key on the taper
end.
Purchase bolts Grade 8 metric socket head approx 5.40" long, or cut off the
factory tie bolts and re-thread the cut ends 3/8"X 24 for use as studs.
Spotweld nuts and install. Mazda using a weird thread, 9.1mm? and hard to
find bolts
Note one bolt on the filter side is longer than this.
The old front rotor oil spray hole can be used as the thrust bearing oil
spray hole but must be plugged off with a #10-32 screw and a new (.079)2mm.
hole drilled in the screw.
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org