Subject: Parts needed to convert to 2-cycle oil metering
From: Paul
Date: 6/3/1999, 10:26 PM
To: zz

Marvin Kaye wrote:

At 08:58 PM 6/3/99 -0700, you wrote:

Sounds like you are cantilevering the engine off the front cover Marv.
The load is a minimum of four G's downward at the CG of the
engine/PSRU/prop combination. Assuming that is three hundred
pounds.... four G's makes that 1200 pounds. So the moment
on your motor mount would be about 14,400 to 16,000 inch
pounds assuming the combination CG is 12 to 14 inches forward
of the front cover.

The distance from the bottom of the engine to those
bolts is only five inches so the shear load on those bolts
due to the moment alone is about 3000 pounds.  Six G's would
of course be 50% more or 4500 pounds. You need to add to that
the 1200 pounds of simple shear. It is not a good idea to
cantilever the engine off the front cover.

Does not sound strong enough Marv. I will wait for the pictures
for final evaluation.


I was initially concerned with my decision but after looking at the
available mounting locations and considering the fastener count and
combined cross section available (and having the entire thing viewed and
critiqued by several folks with more kowledge about such structures than I)
I laid most of my fears to rest and went ahead.  The primary load is
carried by 4 large (9-11mm) bolts off the top of the engine, the rest is
carried by an additional dozen bolts at the lower 2 corners.  You'll see
when the photos come back... I would, of course, be amenable to considering
optional mounting points, as long as they are at the rear of the engine and
don't interfere with the turbo or other systems.  BTW, this mount system
closely resembles that which Neil K. has been using successfully for some
years now.

    <Marv>


The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org