Subject: Parts needed to convert to 2-cycle oil metering
From: Paul
Date: 6/3/1999, 10:28 PM
To: zz

Marvin Kaye wrote:


JMLBlues@aol.com wrote:

I have no parts in front of me to confirm, but I would think the blanking
plate approach should be fine. The only concern that occurs to me is
that the
drive arrangement must put some thrust into the metering pump driveshaft. I
don't know if the thrust is reacted by the pump or by a shoulder on the
shaft
running against something inside the cover. Gear drives tend not to like
running without a load, so presumably there could be some funny
oscillations
or torsional activity, but the whole system is so lightly loaded to begin
with it would probably take about forever to manifest a problem.

Seems to me that removal of that pump driveshaft and related components
would be in order before blanking its holes.  At least that is what I plan
on doing before reassembling the engine without the pump.

   <Marv>


The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org