Marvin Kaye wrote:
At 06:37 PM 6/3/99 -0700, you wrote:
MAR34807@aol.com wrote:
Why not just put on a blocking plate over the spot where the pump was? It
seems unnecessary in his application (cars) to go thru the hassle of taking
off the front cover just to remove the shaft, gear and associated parts.
The
oil can still feed thru if the plate is correctly fashioned, and drain back
to the case. True, you have extraneous parts left inside, but so what?
Based on what Jon says about the oil feed to the shaft and injection
pump pressure being atmospheric I see no reason why not.
Paul Lamar
I've used that entire corner of the front cover as a mounting point for one
of my engine mount adapters... as soon as I get my current batch of photos
back from the lab I'll send one along showing the treatment I gave that
corner. The mount adapter is welded up out of 2 pieces of 4x4x.250 6061T6
angle and uses the holes around the oil feed line and the injection pump
mounting bolts to attach to the front cover, and 4 additional oil pan bolts
around the bottom of the engine for the other attachment. The bracket is
drilled and tapped for the oil line and provides the cover over the
injection pump drive hole all at the same time.
<Marv>
Sounds like you are cantilevering the engine off the front cover Marv.
The load is a minimum of four G's downward at the CG of the
engine/PSRU/prop combination. Assuming that is three hundred
pounds.... four G's makes that 1200 pounds. So the moment
on your motor mount would be about 14,400 to 16,000 inch
pounds assuming the combination CG is 12 to 14 inches forward
of the front cover.
The distance from the bottom of the engine to those
bolts is only five inches so the shear load on those bolts
due to the moment alone is about 3000 pounds. Six G's would
of course be 50% more or 4500 pounds. You need to add to that
the 1200 pounds of simple shear. It is not a good idea to
cantilever the engine off the front cover.
Does not sound strong enough Marv. I will wait for the pictures
for final evaluation.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org