Subject: Parts needed to convert to 2-cycle oil metering
From: Paul
Date: 6/3/1999, 9:43 PM
To: zz

JMLBlues@aol.com wrote:

I have no parts in front of me to confirm, but I would think the blanking
plate approach should be fine. The only concern that occurs to me is that the
drive arrangement must put some thrust into the metering pump driveshaft. I
don't know if the thrust is reacted by the pump or by a shoulder on the shaft
running against something inside the cover. Gear drives tend not to like
running without a load, so presumably there could be some funny oscillations
or torsional activity, but the whole system is so lightly loaded to begin
with it would probably take about forever to manifest a problem.


The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org