Subject: Grooves in rotor housing water jackets.
From: Paul
Date: 6/5/1999, 8:56 PM
To: zz

JMLBlues@aol.com wrote:

As I mentioned, I am aware of the grooving technique, as Racing Beat (and
others) have been using it for years, but I was not aware that the grooving
was down to the steel! If in fact this is common practice and with many
successful hours of use, my reservations are clearly misplaced.

The high stress is on the surface. Any depth of groove will reduce the
material
resisting the stress and in theory increase the deflection so
making the groove deeper relieves the thermal stresses out near
the end and intermediate housings. I have the formula around here
for a beam. I will look it up and make some calculations.


Since our business is to supply engines to a price-sensitive marine market,
we need to keep our manufacturing costs as low as possible. Therefore, we do
not modify the basic engine block in any way. If we were to open engine
blocks for modifications, we would increase the cost of the product out of
proportion to any performance improvement gained, except perhaps for
competition use. Also, since most (non-boosted) performance modifications are
aimed at making the engine breath better to produce more power at higher
RPMs, they are not of much use in a marine application. This is because
marine transmissions are limited to ratings of 5500 rpm (so we're pushing
them at 6250), and also since boats often need adequate torque to pull a
skier out and get on plane. Performance modifications often hurt the torque
curve at low speeds while improving the curve at the higher speeds.

We don't need to do cooling system mods because we fortunately have a very
efficient heat sink in the marine environment.

Regards,
Jon

Yes I know. Just joking about your not doing it. :-)

Paul
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org