Subject: Grooves in rotor housing water jackets.
From: Paul
Date: 6/5/1999, 10:38 PM
To: zz

If we take a beam one inch wide and 1.25 inches long (l) made entirely
out of aluminum 0.3 inch thick and apply a uniform load (W) to the
bottom
of the beam of 1000 PSI we get a max deflection in the center of a 
simply supported beam of:

y = 5/384 Wl^3/EI

The deflection is shown to be a strong (cube) function of the
length of the beam so it being only 1.25 inches long helps
greatly.

E is the modulas of elasticity of aluminum which is 10 million
and I is the section moment of inertia. All units are in inches. 

I for such a section is 1/12(b*d^3)

b is the width of the beam and d is the height or depth
of the beam.

As you can see the depth of the beam is most important
as "I" is proportional to the cube of the depth and 
only directly proportional to its width.

So taking out half the width of the top of the beam in the form of
groves
will result in less than double the deflection as we are shifting
the neutral axis towards the bottom. If the deflection is 0.001
then we will get less than 0.002 by grooving the inside of the
water jacket.

This is kind of a worst case scenario as the bottom of
the beam is steel in the engine so the neutral axis
is closer to the bottom than it is to the top of the beam to 
begin with. Another factor making this worst case is I assumed 
the beam is simply supported. If the ends of the beam are fixed
to a much more ridgid structure (and they are) the deflection
would be less. Unfortionately it would take FEA to get 
the real deflection out of this so what ever we may calculate
here will be way more than the real deflection.

Another factor working in our favor is the aluminum is likely
to be cooler with grooves in it. This will improve it ability
to resist stress.

Paul Lamar

The  Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org