Subject: How to make a one rotor engine e-shaft
From: Paul
Date: 6/5/1999, 8:00 AM
To: zz

virgil n. salisbury wrote:


Gerry Hess wrote:
snip
Purchase bolts Grade 8 metric socket head approx 5.40" long, or cut off the
factory tie bolts and re-thread the cut ends 3/8"X 24 for use as studs.

        Rethreading with a die may give threads with a sharp "V" on
        the bottom of the threads. Rolled threads on a new bolt
        should be rounded at the bottom of the threads. You may
        lose strength by using a die. Is the reduction of strength
        a problem?? Also the new threads sharp top may call for
        tightening up the die for a smaller O D for the bolt thread.
        I have run into this before as the tapped manufactured hole
        also has a rounded bottom opposing the sharp threads cut by
        the die. IS THIS CLEAR ??? VIRG


 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org