Subject: The E-shaft oil jet modification 'thing'
From: Paul
Date: 6/5/1999, 6:57 AM
To: zz

Brian D. Cain wrote:

Guys, I wanted to relay a bit of information to you based on some of
My experience with the oil jet modification(s) available for the eccentric shaft.
While I'm lacking a critical oil temperature gauge, which would make all of
The difference, I've been watching my mech oil pressure gauge for the past
Several thousand miles since last rebuild.

My oil system is as follows:

1987 Mazda 13B 4-port block,  turbo-charged system
Oil pan baffle plate
Factory oil cooler on SS-braided oil cooler lines
(5) M7 flat washers for front e-shaft oil bypass pellet disengagement
"Holley fuel jet" modification to both rotor bearing oil sprayers (e-shaft)
Factory oil pressure regulation (60 to 70psi range)
Factory oil metering (barf, for now)

I don't know how much of an issue this might be to you guys, but
I'm showing, at approx 175F water temps, 12 to 14psi of oil pressure at
A 750rpm idle speed.  Although I can't prove anything, it seems to me that
This idle pressure is a hair bit low.  Apparently the modification to the
e-shaft increases oil dumping quite a bit and, on the factory regulator, a
significant drop in pressure in the mid 1000rpms range.  I have to keep an
idle of ~1100rpm to sustain around 20psi - and this is in moderate, ambient
temps notwithstanding hot, Texas summer days.

Just wanted to let you guys know who are thinking about this.

B

You could drill them out and leave the ball check valves in there
with the spring. That way it would flow more oil only after
the RPM got high enough to cause the ball to come off the seat.

Paul Lamar

The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org