Anderson Ed wrote:
Paul wrote:
Bob Darrah wrote:
Anderson Ed wrote:
Snip.
If anyone has a suggestion about how to vent the header tank for vapors
and not have the boost pump push fuel thru the vent, I would be
interested. But, so far have not had vapor build up problem since these
changes. I would most expect it on ground runup on a hot day so we will
see in August.
Ed Anderson
This doesn't meet your stated requirements, Ed, but the end results are the same.
Vent your header tank into your mains. The fuel pump will still pump fuel
through the vent, but you still contain the fuel.
Bob Darrah
We are going to add "Don't put your header tank on the outside of
the firwall" to our list of fuel systems do's and don'ts.
Ok, sounds reasonable to minimize vapor lock.
Also if you are running a high pressure EFI system "Use a large
header tank or route the return supply to the main tanks"
Ditto
"Use a vented header tank and don't push fuel through it."
May not be viable suggestion for all applications/configurations. If
using a vented header tank then you won't get the pressure differential
from the EFI pumps that would "suck" fuel from the main tanks. If
gravity feed is possible this may be OK, but if not then you will need a
pump running to keep the header thank full. That in turn runs the risk
of pushing fuel out the vent - perhaps automatic shut off?
"Immerse the high pressure pumps in the header tank if possible."
Would help keep the pump cooler
"Run only one pump at a time"
Under all conditions?? I run both of mine on Take Off and Landing as a
safety factor should the primary quit slow and low.
Do I hear any others?
How about, "Aways vent main tanks"?? Even if they do not collapse from
the pressure differential, it can impede the fuel flow as I found when
sucking from the unvented plastic tank.
Ed Anderson
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org