Subject: Grooved rotor housings.
From: Paul
Date: 6/7/1999, 8:34 AM
To: zz

Marc Pedings wrote:

Ken Powell wrote:
     <snip>
     someone could bring a rotor housing that has been modified with the
     water jacket grooves I would appreciate it (not you Paul since you are
     flying commercial).  This has got to be simple, but I would surely
     like to see it before taking out the grinder (what size burr is
     used?).  I'll try to remember to bring a housing with me in case no
     one else can bring one.


Has anyone considered 'dimpling' the housings as well as the grooves?  Random
dimpling should effectively increase the cooling the surface area and increase
the coolant turbulence too, especially in the areas where the carbide wheel
cutter cannot reach.  (another note to consider).  Has anyone enlarged the areas
where the collant flow is restricted the most. (referring to the coolant passages
around the spark plugs and the exhaust port)?

Marc Pedings

Everette Hatch did that on his engines. He merely ported out the water
jacket
to increase the volume of water. He then re-inforced the inner wall with
bolts and found they were uneccesary. I myself would stick to the gooves
as it provides a stiffer inner wall and increases the area of aluminum
in
contact with the coolant.
 
Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org