Subject: Grooves in rotor housing water jackets.
From: Paul
Date: 6/7/1999, 3:49 PM
To: zz

Marc Pedings wrote:

JMLBlues@aol.com wrote:

As I mentioned, I am aware of the grooving technique, as Racing Beat (and
others) have been using it for years, but I was not aware that the grooving
was down to the steel! If in fact this is common practice and with many
successful hours of use, my reservations are clearly misplaced.


Same here. I didn't know they were cut that deep!

The high stress is on the surface. Any depth of groove will reduce the
material
resisting the stress and in theory increase the deflection so
making the groove deeper relieves the thermal stresses out near
the end and intermediate housings.

I didn't know the grooves were that deep.  Are they?  Would the coolant in the
grooves have a tendency for nucleate boiling because of the lack of flow within the
groove itself?  Anyone with experience on this, please enlighten me.  The most I
have ever done to a rotor housing is dimpling.

There is a school of thought that maintains cooling is inadequate
without 
nucleate boiling. The little steam bubbles must be carried off by the 
general flow however. A steam pocket on the other hand is defined to 
be much larger and is stationary.

The depth is down to the steel teeth and not to the liner itself.
The steel teeth are there to lock the liner to the aluminum water
jacket.
I am sure the depth varies and depends on who is doing the grinding.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org