Todd Carrico wrote:
Bill Freeman wrote:
Paul,
The web site is
http://www.parker.com/stratoflex/news
and click on the article "Be Hose-Safe"
By the way, Parker does not report the
leakage of the teflon lined hoses here, only
the shelf life issue and general good information
about hoses in your aircraft. The hose leakage if
from Lt Plane Maintenance or Av Consumer, --
a SDR (service diffifulty report) on the
teflon lined hoses.
For clarification, teflon hoses are not dangerous,
per se, just EXTREMELY expensive and not
particularly better than Stratoflex 111 hoses, other
than they are a bit lighter and look really cool. The
main advantage is for wholesalers who can keep premade
hose kits on the shelf indefinitely. With the rubber hoses
they have a shelf life, even when unused.
<<<<< SNIP >>>>>
Bill
I used to build Air Craft hoses for a living. The Teflon
hoses are lighter and will take as much preasure as the 301.
The difference starts to get obvious with the bigger dash no's.
-10 and up you can really appretiate the weight difference.
301 is the equivelent of the bribk s**t house for hose. Great
brake lines due to the fact that it doesn't flex much with
pressure. Reminds me of tractor hoses.
The AeroQuip teflon hose used to have a carbon liner. I am not
sure if this is a good thing or not. It was suposed to cut
down on static electricity generated with high flows (Fuel
in a turbine for example). Also, the teflon would flow into
the braid, and could take a set. Would make them very hard
to straighten out and measure (to build replacements), but
may have been a benefit in service.
While we are talking about fuel system hoses, I will get this
in.
All hoses on the engine side of the firewall must be firesleeved.
Proper firesleeve is sealed on both ends. Seal it with a diluted
mixture of RTV. Should be the consistencey of honey.
This must be clamped to the hose fitting to preclude fuel from
whicking into the firesleeve. Fuel soaked fiberglass will not
do you any good in an engine fire.
Second, a good anual or 100 hr inspection should include a
visual inspection of the hoses. The only way to do this is to
pull the firesleeve off, inspect (Pressure is best) and put the
fire sleeve back on.
BTW we pressure tested our hoses for three minutes at
three times operating pressure. We used water/water
soluable oil as the testing agent, but any light bodied
liquid will suffice. Better to have them leak on the test
stand than in service.
I will be using the equiveilent of AeroQuip 701 if they haven't
found any thing wrong with it by the time I am ready. When
I was in the business, AeroQuip had the better fitting system
(Fewer parts), but Stratoflex had a steel ferrel (a spereate
peice) that would probably make it more "reusable". The hose
is manufactured by Parker, so the only difference is price, and
the style of fittings, and customer service ;).
tc
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org